XenonZcar Banner
Shop
XenonZcar Full Service Shop

Z31 Headlamp Down Mod (Sleepy Eyes)

With this mod, your Z31's headlamps stay closed when you turn on the low beams, and the car runs on its front driving lights. It gives the nose a clean, low look at night.

It costs nothing, takes about 10 minutes, and you undo it by plugging one connector back in.

At a Glance

Fits
All 1984-1989 Z31s (the connector is in about the same spot on every model)
Tools
A screwdriver
Time
About 10 minutes
To undo
Plug the connector back in
What this version does: the headlamps stay down with the low beams on. They still pop up when you turn on the high beams or press the headlamp switch, and once up they stay up. The car in the video below also has a relay mod, not covered here, so only the switch moves its headlamps.

How to Do It

  1. Remove the lower dash panel on the driver's side. Take out its three screws, then unplug the vent selector vacuum line and the kick panel lamp.
  2. Look just to the right of the steering column for a small black two-wire connector, about an inch long. It can be hidden behind other wiring, so move the harness aside if you don't see it.
  3. Unplug the connector. That's the mod: the headlamp motors no longer raise the lamps when the low beams come on.
  4. Turn on the lights and check that the headlamps stay down.
  5. Check that the headlamps still pop up with the high beams and with the headlamp switch.
  6. Tuck the loose connector out of the way so it can't rattle, then reinstall the dash panel.
The two-wire headlamp connector unplugged under the Z31 dash
The two-wire connector.
Where the headlamp connector sits to the right of the steering column
Where it sits, right of the steering column. It's often buried in other wiring.

See It in Action

Video by MuhKayden. This car also has the relay mod, so its headlamps stay down even with the high beams on.

Credits

  • Photos: Louis Miller
  • Video: MuhKayden on YouTube