XenonZcar Banner
Shop
XenonZcar Full Service Shop

Z31 Fog Light Mod: Fogs With the Parking Lights

Z31 300ZX with the fog lights on

From the factory, the Z31's fog lights only work with the headlights on. This mod rewires the fog light relay so the fogs work with the parking lights instead, and stay on with the high beams. You still turn them on and off with the stock fog light switch. It's a simple job: one cut wire and one new wire.

Check your local laws. Fog light rules vary by state; some don't allow fog lights without the low beams on, or with the high beams.

What You Need

  • Test light or multimeter
  • Screwdrivers and a small socket set
  • A length of automotive wire and some split loom
  • Wire strippers, a soldering iron and heat-shrink tubing (or butt connectors)
  • Electrical tape
Disconnect the negative battery cable before you cut or splice anything. Soldered, heat-shrunk splices last much longer than tap-in connectors, which tend to corrode.

1. Find the Relay and the Trigger Wire

The fog light relays are in the relay box under the hood. Pull the fog light relay and check its socket with a test light: one terminal has power all the time, and the trigger terminal only has power when the headlights are on. The trigger is the one you'll rewire.

Relay box under the hood of a Z31
The relay box under the hood.
Test light lit on the constant power terminal
Constant power: lit all the time.
Test light off on the trigger terminal with the headlights off
Trigger terminal, headlights off.
Test light lit on the trigger terminal with the headlights on
Trigger terminal, headlights on.

2. Cut the Trigger Wire

To get under the relay box, remove the screws holding the coolant overflow tank and move it aside. Unbolt the relay box and flip it over. The trigger wire for the fog light relay is a small orange wire with a black stripe.

Cut it, leaving enough wire on the relay box side to splice onto. Tape off the other end well so it can't short.

Orange and black fog light relay trigger wire under the relay box
The orange/black trigger wire.
Trigger wire cut, one end taped off, with the new power wire
Cut, one end taped, and the new wire ready.
Cut end of the trigger wire taped off
The cut end taped off.

3. Run the New Power Wire

Run one wire from the relay box out of the engine bay to the side marker light in the passenger front fender and wheel well area. The marker light connector has two wires: red is power and black is ground. Splice the new wire into the red power wire.

Then connect the other end of the new wire to the relay-box side of the trigger wire you cut.

The new wire only switches the relay's coil, so it draws very little current and won't overload the parking light circuit.
New wire spliced into the red power wire at the side marker light
Spliced into the marker light's red power wire.
New power wire connected to the trigger wire at the relay box
Connected to the trigger wire at the relay box.
New wire routed in loom, and the finished fog lights on
Routed in loom so it's hard to spot.

4. Test and Reassemble

Reconnect the battery and put the relay back in. Turn on the parking lights and the fog light switch: the fogs should come on without the headlights, and the stock switch should still turn them on and off.

Once everything works, bolt the relay box back in and reinstall the coolant overflow tank.

Credits

  • Written by Keif Potter